Spring Machine
Forming Machine

RX series
MX-20B
MX series
RM-20
MS-20
MCS-10
MCS-20
RS-8
AX series
MCS series
SX series
MF-10B
FX series

Coiling Machine
PCX-30
PCX series
PC-8A
PC-4
CX series
CX-2A
CS-8
CK-8

discontinued
SCD-7
MCS-G series
MCX series
PC/PC-H Series
SCD-5


Ultimate machine for the coiling of
extremely fine wire make it debut!




Computer Controlled Coiling Machine

The CX-2A is optimized for the coiling of extremely
fine wire; From 30 micron to 200 micron



CX-2A Computer Controlled Coiling Machine
CX-2A

The CX-2A provides the easiest and most precise way of coiling
the very fine wire based on the newly developed Feed Unit
and Servo Slides & the precise tool technology.
CX-2A has 5 axes as standard; Feed axis, Cut axis, Diameter axis,
Push Pitch axis, Arbor forward / backward axis.




Feed Unit position can be adjusted Horizontally (Patent)
The position of Feed Unit can be adjusted horizontally 15mm. When the relative position between the Feed Roll and the Wire Guide or the Length of the Wire Guide have changed, you can adjust the horizontal position of Feed Unit so that the front edge of Wire Guide is in contact with the Arbor.


Servo Slides can be installed at any angle
You can install the Servo Slide at any angle on the Slide Table according to the various way of coiling such as 1 or 2 point, the push pitch or the wedge pitch.
(Servo Slide for One Point Coiling and Push Pitch are equipped as standard. Optional slide, tools, etc. are necessary for 2 Points Coiling.)



Feed Roll Dia. is 20mm, Wire Guide Length is 10mm
The most important point of coiling very fine wire is to make the Feed Roll Dia as small as possible and to make the Wire Guide Length between the Feed Roll and the Arbor as short as possible.

Wire Guide has an integrated style
The front end and back end of Wire Guide are integrated, thus the alignment of wire is very easy.






Specification
Machine Specification

CX-2A
Forming Capacity Wire Dia. 0.03-0.2mm
Min. D/d 4
Outside Diameter3.0mm max.
Feed(2axes) Min. Increment 0.002mm
Moter Power 50W
Max. Speed 122m/min
Cut Min. Increment 0.1
Moter Power 30W
Outside Diameter Min. Increment 0.001
Moter Power 30W
Push Pitch Min. Increment 0.001
Moter Power 30W
Arbor forward/backward Min. Increment 0.001
Moter Power 30W
Pneumatic Solenoid Valves
2pcs.
Peripheral Device Control
16ports
Power Requirement 3 Phase 10A
Dimension Height 1626mm
Width 1223mm
Depth 964mm
Net Weight
500kg

sample
Sample


Computer Specification
CPU Pentium Processor
Program 2000 Steps
Program
Storange
USB Flash Memory
3.5inch FDD
Display 15inch TFT
Color LC Display
Operating
Temp.
0 - 45 degree
"Linux" is a registered trademark of Linus Torvalds of U.S.A. in U.S.A and other countries.
Please note the contents of this web page is subject to change without notice.